eXpert Door Edge Protection Film (Clear PPF) - 2025+ 4Runner

eXpert Door Edge Protection Film (Clear PPF) - 2025+ 4RunnerProtects trail edge of doors Protection while in tight spaces Easy to install Sold as a set for 1 entire vehicle eXpert Door Edge Protection Film (Clear PPF) Door edge protection is one of of the easiest peace of mind products to purchase and install. Pre cut templates allow for easier installations. With cramped areas and lots of passengers, your doors are susceptible to a little paint damage when opening them. Recommended items: This Kit StickerFab

• Protects trail edge of doors
• Protection while in tight spaces
• Easy to install
• Sold as a set for 1 entire vehicle

eXpert Door Edge Protection Film (Clear PPF)

Door edge protection is one of of the easiest peace of mind products to purchase and install.  Pre-cut templates allow for easier installations.  

With cramped areas and lots of passengers, your doors are susceptible to a little paint damage when opening them.

Recommended items:

• This Kit
• StickerFab Installation Fluid (1 bottle)
• Microfiber
• Squegee (optional)
• Detailer spray to prep the area (without wax)
• Heat gun or hair dryer on standby

Material

Clear Oracal ORAGUARD 270G stone protection offers a transparent solution to paint protection.  It is 6 mil in thickness.

INSTALLATION

We recommend doing this after a fresh car wash.  Re-clean the application area to prepare it for installation.  Just use a wax free detailing spray if your vehicle is not too dirty.  Do not forget to clean the back side of the door edge.  Also wash your hands.  You do not want to get dirt stuck to the adhesive side of the PPF.

NOTES:  We recommend that the installation area be free of wax and not under direct sunlight.  You will want to do this in 70-80 degree weather ideally.  Any colder and you will definitely want to keep a hair dryer / heat gun on standby. 

Apply application fluid to the target install and nearby surrounding area.  Also apply it to the back of the PPF as it is removed from the backing paper.  Apply it to your fingers for bonus points.

With a liberal amount of application fluid on the target area and PPF, you can change the alignment of the PPF by gently pulling up on portions and setting it back down.

Once you alignment is ideal, you can start to squeegee out the liquid with your hands and / or a small squeegee.