Creative Personality Gas Lighters Carriage Wine Barrel Golden Retro Nostalgic Ornaments Gift

Creative Personality Gas Lighters Carriage Wine Barrel Golden Retro Nostalgic Ornaments Gift1. How to operate the correct inflation 1. Before inflating, use small tools to resist the inflation core, completely release the residual gas inside, so as to eliminate the pressure in the gas tank of the lighter; 2. Press the gas tank outlet of the gas vertically downward for about 5 seconds each time, two or three times. 3. Please wait about 5 minutes to use after the inflation is completed. If there is still no fire after 5 minutes, please adjust

Detailed inflatable introduction:

Gas filling method

1. When adding gas, there should be no Mars or fire around, so ensure safety. Do not smoke while adding gas;
2. Qualified butane gas should be used, and inferior gas may damage the lighter or reduce the service life;
3. When filling the gas for ordinary models, please stand the lighter upside down, align the gas bottle outlet and cover the lighter air inlet, press it several times with force, and keep it for about 2 seconds each time; If the gas cannot be filled, it may be that there is excess air left in the Steam Box. At this time, you can deflate the air, and use a small screwdriver to immediately deflate the Air 1-2 times in alignment with air inlet, and then perform the air filling operation;
4. When the Langsheng machine is aerated, loosen the air inlet screw cover with tools such as a slotted screwdriver, and then follow the above steps. After the air filling is finished, the screw cover can be screwed flat, not too tight; Otherwise, the machine cover cover will not be dense and the Machine cover sound will not be crisp, and the gas will escape. Hardcover Langsheng machine should use special air nozzle to add gas; 5. When the gasoline engine is refueling, open the head cover, pull out and reverse the movement, open the outer sponge and add appropriate amount of gasoline. After the gasoline penetrates into the inner layer, cover the outer sponge, and then put it into the casing;
6. After all kinds of lighters replenish fuel, wait at least 1 minute to adjust the temperature of the newly filled gas to room temperature, and wait until the residual gas attached to the lighter is completely volatile before ignition. If the ignition operation is carried out immediately at this time, the residual gas on the surface of the lighter may burn, causing unnecessary danger. After re-supplementing the gas, if the flame height is too high or too low during use, it is normal, and the flame height can be adjusted appropriately.

Regulating flame
1. When using, as the gas content of the product decreases and the temperature of the surrounding environment changes, the flame height will change to a certain extent, which is a normal phenomenon. You can adjust the flame height moderately;
2. When using, the normal flame height should be controlled at; Windproof and direct punching lighters are 1.5-2.5cm; Langsheng, gasoline and open flame lighters are 2.5-4.0cm;
3. If you need to adjust the flame height, please use a screwdriver to align the flame regulator groove; If the lighter itself has adjustable ring, you can directly adjust it with your fingers to (-) the direction of the arrow is clockwise, and the flame height can be adjusted to low; The direction of the arrow is counterclockwise, which can increase the flame height. Note: rotate counterclockwise and cannot exceed half a circle based on the normal flame height. Otherwise, this product may be damaged;
4. The gasoline lighter should control the flame height by adjusting the ignition height of lamp wick. If the flame height is too high, scissors can be used to cut a little lamp wick; If the flame height is too low, lamp wick can be pulled out appropriately.

Precautions
1. Contain pressurized flammable gas, please stay away from children;
2. Do not puncture or throw a lighter, and do not throw it into the fire;

3. Please use it in a ventilated environment and pay attention to flammable items;
4. Fire head is strictly prohibited to face, skin, clothing and other combustible substances to avoid danger;
5. Please check the position of burner when igniting, and press the ignition appropriately. Lighters of different styles are ignited in different ways: they can be divided into straight beating, side beating and side beating; Gasoline engines should quickly rub grinding wheels, and Langsheng machines use thumbs to quickly rub rollers from right to left;
6. When using, if any impurities such as soot accidentally fall into burner, blow it in time to remove the sundries, otherwise it will cause bad fire;
7. Langsheng and gasoline lighters, for example, as soon as the Machine cover is opened, the gas starts to escape. Therefore, when the machine cover is not ignited, be sure to cover the Machine cover for storage;
8. This product is not suitable for lighting. Do not burn continuously for more than 1 minute to avoid scalding skin with high temperature;
9. Do not put the lighter in a high temperature environment (50 degrees Celsius/122 degrees Fahrenheit) for a long time, and avoid direct sunlight for a long time, such as the surrounding stove, outdoor closed unmanned carriage and trunk;
10. As the climate above 3000 meters above sea level limits the combustion conditions, the ignition of windproof and direct impact lighters may be greatly affected. We recommend that you use an open flame lighter;
11. When using arts and crafts lighters such as desktop lighters, the positions of burner, press, air inlet, and flame regulator should be clearly defined for correct use.
12. Qualified butane gas should be used. Inferior gas may damage the lighter or reduce its service life.